g.j.p.a.a.baltissen@kader.hobby.nl (Ruud Baltissen) wrote: > I lately repaired a 8296 by replacing its PLA-chip. But it starts up in the > monitor mode. Is this normal? If not, what should I see? No. You should see the same as with a 8032. When it ends up in monitor mode, does it do that with a C* or a B*? If C*, it thinks the diagnostic sense line is held down (C* is shown if the monitor is explicitly Called). If B*, it came there via a BRK which is bad. > Groetjes, Ruud -Olaf. -- ___ Olaf 'Rhialto' Seibert rhialto(at)mbfys-dot-kun.nl "I would be dead in \X/ a week if I didn't do /something/. I'd be splattered all over the walls." - This message was sent through the cbm-hackers mailing list. To unsubscribe: echo unsubscribe | mail cbm-hackers-request@dot.tcm.hut.fi.
Archive generated by hypermail 2.1.1.