On Sun, 15 Aug 1999, Geoff Oltmans wrote: > I guess I should have been a little more specific in my original post. I > have isolated the problem to the spindle motor control board, since: A. an > exact replacement mech works just fine in the machine. B. Spindle bearings > are free with no excessive play. You CAN get the drive motor to spin if > you give it a bit of a push-start by hand, but 9 out of 10 times the thing > won't start on its own. Although they say to check the moter control board, they do not provide any information on it. Bill - This message was sent through the cbm-hackers mailing list. To unsubscribe: echo unsubscribe | mail cbm-hackers-request@dot.tcm.hut.fi.
Archive generated by hypermail 2.1.1.