From: Nicolas Welte (no_spam_at_x1541.de)
Date: 2006-10-04 17:18:48
Hi Marko,
-------- Original-Nachricht --------
Datum: Wed, 4 Oct 2006 00:17:26 +0300
Von: "Marko Mäkelä" <marko.makela@hut.fi>
> I guess it won't fit into the 128DCR with the case installed, will it?
> At least it shouldn't fit into the side port of the CBM 200 a.k.a.
> 8032-SK,
> unless your cases are lower than those used previously.
The cases are the same height, being Sub-D adaptors, too. The old ones were 9-25 adaptors, the new ones are 9-9 adaptors. Both work fine with the 128DCR, and the IEC port can be installed as well, with a cable plugged in.
I made a test with my CBM 8296, and only the bare C2N232I board will fit into the side port. No case, no IEC port. I don't have a 8032-SK, but I think it is similar (maybe with the side port on the left side instead of the right side).
Nicolas
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.