Re: hardware for sale

Hi Julian,

I went the switch mode way because in the SFD drives the transformer connects to a seperate pcb that contains the rectification and regulation components, and on my units those components were in need of replacement. With that and the need to replace the transformer I decided a more modern answer was best. Naturally I used the original mains IEC input and switch so that the drive, from the outside, maintains the original look.

The caged Meanwell supplies fit quite nicely in to the space vacated by the original power internals and connect to the controller pcb using the original wiring loom I removed.

Mike

Sent from my iPhone

On 30/04/2013, at 12:43 PM, Julian Perry <jp@digitaltapestries.com> wrote:

> Hello Mike,
> 
> 
> Actually, judging from the PSU schematic I suspect just swapping out the transformer from the carcass of a dead 1541 would be sufficient.
> It would certainly be worth double-checking first, though :)
> 
> I'm actually very interested in the SFD1001 - it'd sure take up less space than my D8250LP  :)
> 
> Julian
> 
> 
> > Or pickup a nice internal switch mode power supply from a local
> > electronics supplier. I purchased a couple of dual voltage (5/12v)
> > units made by Meanwell to convert a couple of SFDs I purchased from the US.
> 
> > Mike
> 
> > Sent from my iPhone
> 
> > On 30/04/2013, at 8:31 AM, Rob Clarke <crock@clarke-family.org.uk> wrote:
> 
> >> Evening gents,
> 
> >> I repaired a 2031LP about 6 months ago and I'm 90% certain the PSU is the same as a 1540/41.
> 
> >> Rob
> 
> >> On 29/04/2013 23:30, Michał Pleban wrote:
> >>> Hello!
> 
> >>> Anders Carlsson wrote:
> 
> >>>> How much does the 2031LP power supply differ from e.g. a 1541 power
> >>>> supply? I mean could you take the internal 230V PSU from a 1541 and
> >>>> transplant it into a 2031LP?
> >>> That's a good question. I don't have a 2031LP yet (I have been looking
> >>> for it for over a year now), so I can't check. But this is very probable.
> 
> >>> Regards,
> >>> Michau.
> 
> 
> >>>        Message was sent through the cbm-hackers mailing list
> 
> 
> >>      Message was sent through the cbm-hackers mailing list
> 
> >        Message was sent through the cbm-hackers mailing list
> 
> 
> 
> -- 
> Best regards,
>  Julian                            mailto:jp@digitaltapestries.com Message was sent through the cbm-hackers mailing list


       Message was sent through the cbm-hackers mailing list