Re: Re: VIC-20 IF BOARD

Ruud,

Before going to the "unknown hardware drawer", could you provide a picture of each side ?

Tous vos emails en 1 clic avec l'application SFR Mail sur iPhone et Android - En savoir plus.


========================================

Message du : 24/04/2014 19:58
De : Ruud@Baltissen.org
A : silverdr@wfmh.org.pl, cbm-hackers@musoftware.de
Copie à : 
Sujet : Re: VIC-20 IF BOARD


 Hallo allemaal,


> Maybe it goes to the vic 20 joystick port?

That was my first thought as well. But GROUND goes to pin 2, not 
pin 8. OK, one could still make a cable that connects the various 
digital pins of the joystick to the digital ones of this connector. 

But what goes to what ??? And the next question: how is the whole 
to be operated, what commands etc. ???

I could disassemble the ROM and analyse it but to be honest, I 
don't think that it will be worth the trouble at all. If I really 
need something to be printed on a Centronics printer, there are 
enough other possibilities: I have several IEC-Centronics 
convertors, programs that turn the Userport into a Centronics port 
and I thougt SpeedDOS, JiffyDOS and/or Exos V3 support Centronics 
over the Userport as well ???

I will put it in the drawer "unknown hardware".


--
   
Kind regards / Met vriendelijke groet, Ruud Baltissen
www.Baltissen.org







       Message was sent through the cbm-hackers mailing list



       Message was sent through the cbm-hackers mailing list