On 2015-03-26 04:03, William Levak wrote: >> William, there's an issue of Commodore World that contains an article >> on what you need to do in order to use an HD mech in a 1581. >> Unfortunately, I don't recall which issue it is. The good news is >> that the IA has all of them scanned and online. >> >> https://archive.org/details/commodore-world > > I looked up the article. Unfortunately, it's a little vague. > > You cut lines 3 and 34, and juper line 2 to ground. > > I can't make out what jumpers 1 and 2 do. The directions for jumper 2 > say to connect the open end of R2 to pin 34. Does this mean that the > line that was line 3 is now line 34? For jumper 1, it says connect the > end of r15 to ground. Does that mean that the remaining end of line 3 is > grounded? Which issue the article is in? Could you link us to it? Basically it is the same modification that is needed for using the cost reduced PC drives in the Amigas. If you look up publications on Amiga mods rather than 1581 mods (should be more of them available) then it will be the same what is needed here. Out of my head it was swapping the _CHNG and RDY lines but details were available in various publications. -- SD! Message was sent through the cbm-hackers mailing listReceived on 2015-03-26 10:00:05
Archive generated by hypermail 2.2.0.