Re: reading vic20 or c64 column

On 2015-06-30 22:02, didier derny wrote:

> Another problem is to place the Bluetooth module at the right place
> that's why I'm thinking to put a connector with either the hc05 on
> the PCB (if it works), or with a flat cable and hold over the shield with
> double side tape

I believe this heavily depends on the machine you put it in. The "riser"
approach should work very well for the 64. There it by itself can get
above the shield. Might not be that rosy for the metal cased PETs for a
good example.

> the slave module on a breadboard:
> http://6809.eu/usbkey-breadboard.jpg

Nice.

> Another problem: the connector for C116 / Plus4
> I made one with a row of pins with the pins thinned with a diamond file
> (works fine but took me hours to make one)

I /think/ this should be solvable with socket-type pinheads instead of
"goldpin" type. Those are significantly thinner and should fit into
those foil sockets.

-- 
SD!

       Message was sent through the cbm-hackers mailing list