Finally it works at even and odd addresses I observed both case with the oscilloscope ODD and EVEN addresses the differences between both case was that when the code was at odd addresses the A0 line was at the same value for the next cycle, so the hypothesis was that CH376 was removing the data to fast when A0 changed... so I added a small capacitor between A0 and GND (on the CH376) now A0 is delayed and it works where ever is the code (odd/even) how could I solve this problem properly ? I don't like this capacitor on the address bus... thanks to all -- didier On 30/03/2016 22:08, Gerrit Heitsch wrote: > On 03/30/2016 09:44 PM, didier derny wrote: >> if I remove the board and inject a signal on A0 >> I get the signals on other pins a few mv >> a little bit higher on CS >> >> I checked with the oscilloscope >> >> CS / PHI2 with the code odd/even seems ok cs go low on falling edge >> of phi2 / go up on raising edge of phi2 (same for odd and even) > > Huh? According to what I could find, CS is low_active on that chip. > Meaning you need to have CS low when PHI2 is high. > > Gerrit > > > > Message was sent through the cbm-hackers mailing list Message was sent through the cbm-hackers mailing listReceived on 2016-03-31 20:00:02
Archive generated by hypermail 2.2.0.