L1 is the last one i could not spot... its in the left side of the tin box... also at the top L5 is for 5V input... L4 is for 9vAC input... it could be inside a plastic box 2017-02-17 23:37 GMT+01:00 Santo Nucifora <santo.nucifora@gmail.com>: > I only see an L5. Can't see any other L's actually. That goes for both. > > On Fri, Feb 17, 2017 at 5:34 PM, Bo Herrmannsen <bo.herrmannsen@gmail.com> > wrote: > >> L4 is proberly located in the very corner next to the slot and power in >> >> on some boards the are below the slot >> >> but on revC i just figured that we just have 2 equal inductors on the >> came core... red and green wire on the link i posted >> >> 2017-02-17 23:31 GMT+01:00 Santo Nucifora <santo.nucifora@gmail.com>: >> >>> A camera actually works better than a scanner. I can take some pics >>> tomorrow with better daylight. >>> >>> Yes, that's where I read Rev A vs Rev C :) >>> >>> I can find RP4 (resistor pack bear the cartridge slot. Where is L4? >>> >>> On Fri, Feb 17, 2017 at 5:23 PM, Bo Herrmannsen < >>> bo.herrmannsen@gmail.com> wrote: >>> >>>> nope that does not make sense either >>>> >>>> so you are not the only one that dont get date vs rev >>>> >>>> in the link i posted i can see rev C very faint at the bottom edge in >>>> the middle >>>> >>>> just under the component FB10 and next to C93 >>>> >>>> 2017-02-17 23:20 GMT+01:00 Santo Nucifora <santo.nucifora@gmail.com>: >>>> >>>>> I'm not sure where to look. Chip dates are: >>>>> >>>>> - 326298 Rev A - 6502 date: Week 48 82 >>>>> - 326298 Rev C - 6502 date: Week 29 82 >>>>> >>>>> I still don't get Commodore dates vs revisions. >>>>> >>>>> On Fri, Feb 17, 2017 at 5:17 PM, Bo Herrmannsen < >>>>> bo.herrmannsen@gmail.com> wrote: >>>>> >>>>>> Can you see any production dates on the Rev A and Rev C ? >>>>>> >>>>>> 2017-02-17 23:14 GMT+01:00 Santo Nucifora <santo.nucifora@gmail.com>: >>>>>> >>>>>>> Slight change to my last message. I have two boards plus a couple >>>>>>> of extra C64 Silver labels that I don't know what's inside at this point. >>>>>>> >>>>>>> The open ones have: >>>>>>> - 326298 Rev A >>>>>>> - 326298 Rev C >>>>>>> >>>>>>> That picture is a Rev C. >>>>>>> >>>>>>> On Fri, Feb 17, 2017 at 5:13 PM, Bo Herrmannsen < >>>>>>> bo.herrmannsen@gmail.com> wrote: >>>>>>> >>>>>>>> would it be pushing it using a scanner for that? >>>>>>>> >>>>>>>> benefits are able to get better image... >>>>>>>> >>>>>>>> does the board look the same as this: http://myoldcomputer.nl/ >>>>>>>> wp-content/uploads/2015/11/board-326298.jpg >>>>>>>> >>>>>>>> but i need details arround RP4 and L4 >>>>>>>> >>>>>>>> >>>>>>>> >>>>>>>> 2017-02-17 23:07 GMT+01:00 Santo Nucifora <santo.nucifora@gmail.com >>>>>>>> >: >>>>>>>> >>>>>>>>> I have a C64 326298 board in front of me. It's not for sale but >>>>>>>>> I'm happy to take detailed pics if you need them. >>>>>>>>> >>>>>>>>> On Fri, Feb 17, 2017 at 4:47 PM, Bo Herrmannsen < >>>>>>>>> bo.herrmannsen@gmail.com> wrote: >>>>>>>>> >>>>>>>>>> also C48 and C93 is missing >>>>>>>>>> >>>>>>>>>> 2017-02-17 22:24 GMT+01:00 Bo Herrmannsen < >>>>>>>>>> bo.herrmannsen@gmail.com>: >>>>>>>>>> >>>>>>>>>>> @Ruud >>>>>>>>>>> >>>>>>>>>>> Found some errors in your schematic >>>>>>>>>>> >>>>>>>>>>> U31 pin 16 is missing >>>>>>>>>>> C68 is missing >>>>>>>>>>> >>>>>>>>>>> 2017-02-17 21:37 GMT+01:00 Bo Herrmannsen < >>>>>>>>>>> bo.herrmannsen@gmail.com>: >>>>>>>>>>> >>>>>>>>>>>> @Silver no problemo... its no rush. I'm still getting my head >>>>>>>>>>>> to absorb the schematic from the Programmer's Reference Guide and schematic >>>>>>>>>>>> #326106. There are a few differences allready between the 2 and so far i >>>>>>>>>>>> have just put a circle arround them >>>>>>>>>>>> >>>>>>>>>>>> But so far RP4 and L4 is the mystery bits. L4 is just listed as >>>>>>>>>>>> a line filter with no values at all or any mfg code. all i know is that its >>>>>>>>>>>> 2 inductors in one unit >>>>>>>>>>>> >>>>>>>>>>>> RP4 is a resistor pack with one common pin, but given its >>>>>>>>>>>> listed as a 10 pin device there are 9 resistors inside, but i can only >>>>>>>>>>>> count 8 on the schematic so i guess 1 is unused. >>>>>>>>>>>> >>>>>>>>>>>> 2017-02-17 21:23 GMT+01:00 <silverdr@wfmh.org.pl>: >>>>>>>>>>>> >>>>>>>>>>>>> >>>>>>>>>>>>> > On 2017-02-17, at 20:55, Bo Herrmannsen < >>>>>>>>>>>>> bo.herrmannsen@gmail.com> wrote: >>>>>>>>>>>>> > >>>>>>>>>>>>> > @Silver >>>>>>>>>>>>> > >>>>>>>>>>>>> > When you come by the 326298 please let me know. >>>>>>>>>>>>> >>>>>>>>>>>>> As I wrote, I should have one somewhere. The keyword here is >>>>>>>>>>>>> "somewhere". So I might have a quick look but if it's not easily found then >>>>>>>>>>>>> I won't be able to dedicate enough time to dig it out. And - obviously - it >>>>>>>>>>>>> won't be for sale but I might check a thing or two for you if needed. >>>>>>>>>>>>> >>>>>>>>>>>>> BTW. Some time ago I had a short discussion about VIC-20 >>>>>>>>>>>>> boards here. I don't remember know exactly with whom but if the person who >>>>>>>>>>>>> wanted me to check things on those boards reads the list - please come back >>>>>>>>>>>>> with your question again. Seems that I managed to gather /I think/ all my >>>>>>>>>>>>> VIC-20s under one roof so I can check whatever you wanted to check there. >>>>>>>>>>>>> >>>>>>>>>>>>> -- >>>>>>>>>>>>> SD! >>>>>>>>>>>>> >>>>>>>>>>>>> >>>>>>>>>>>>> Message was sent through the cbm-hackers mailing list >>>>>>>>>>>>> >>>>>>>>>>>> >>>>>>>>>>>> >>>>>>>>>>> >>>>>>>>>> >>>>>>>>> >>>>>>>> >>>>>>> >>>>>> >>>>> >>>> >>> >> > Message was sent through the cbm-hackers mailing listReceived on 2017-02-17 23:03:00
Archive generated by hypermail 2.2.0.