Dumb question...is your IEEE drive set to 8? Bill Degnan twitter: billdeg vintagecomputer.net On May 8, 2017 7:05 AM, "Imre Széll" <iszell75@gmail.com> wrote: > > Hello, Ruud, > > have you installed the latest software for the ZoomFloppy? Have you updated the firmware? I seem to remember that old versions did not support IEEE-488 but with version 2.0 it works. > > Regards, > Imre > > 2017-05-08 12:13 GMT+02:00 <Ruud@baltissen.org>: >> >> Hallo allemaal, >> >> >> After I bought my ZF I put it away and then it was lost for some >> years. To make a long story short: I just happen to find it last >> week. >> >> I installed everything according the site of Jim and the PDF. Things >> work fine with my 1571. But the moment I disconnect the 1571 and >> connect my 1001, CBMCTRL just says it is looking for drives and the >> blue LED keeps flashing. Thinking it could be the error of CBMCTRL >> because the help info only mentions the IEC bus, I tried D82COPY but >> with the same result: a flashing LED. >> >> Did I miss something or am I doing something wrong? Any help is >> welcome! >> >> >> -- >> >> Kind regards / Met vriendelijke groet, Ruud Baltissen >> www.Baltissen.org >> >> >> >> >> >> >> >> Message was sent through the cbm-hackers mailing list > > Bill Degnan twitter: billdeg vintagecomputer.net Message was sent through the cbm-hackers mailing listReceived on 2017-05-08 12:01:31
Archive generated by hypermail 2.2.0.