Hallo allemaal, I'm busy with disassembling the command !TRANS. It asks for 4 parameters which are (IMHO): - start address - end address - a byte smaller than 256 used for ??? IMHO even never used. - a character: G, R or C G tells the program to copy data to the graphical memory R tells the program to copy data from the graphical memory C tells the program to swap data with the graphical memory Question out of curiosity: where could these characters stand for? I mean, I would expect to use S for Swap. @Christian: Do you have more info on this command (in fact any command)? Met vriendelijke groet / With kind regards, Ruud Baltissen www.Baltissen.org De informatie in dit e-mailbericht is vertrouwelijk en uitsluitend bestemd voor de geadresseerde. Wanneer u dit bericht per abuis ontvangt, verzoeken wij u contact op te nemen met de afzender per kerende e-mail. Verder verzoeken wij u in dat geval dit e-mailbericht te vernietigen en de inhoud ervan aan niemand openbaar te maken. Wij aanvaarden geen aansprakelijkheid voor onjuiste, onvolledige dan wel ontijdige overbrenging van de inhoud van een verzonden e-mailbericht, noch voor daarbij overgebrachte virussen. APG Groep N.V. is gevestigd te Heerlen en is ingeschreven in het handelsregister van de Kamer van Koophandel Limburg onder nummer 14099617 The information contained in this e-mail is confidential and may be privileged. It may be read, copied and used only by the intended recipient. If you have received it in error, please contact the sender immediately by return e-mail; please delete in this case the e-mail and do not disclose its contents to any person. We don't accept liability for any errors, omissions, delays of receipt or viruses in the contents of this message which arise as a result of e-mail transmission. APG Groep N.V. is registered in the trade register of the Chamber of Commerce Limburg, The Netherlands, registration number: 14099617 Message was sent through the cbm-hackers mailing listReceived on 2017-10-26 14:00:02
Archive generated by hypermail 2.2.0.