Hallo Patryk, > My last (in a series of) attempt failed again. Same for me. I'm still happy with my Eagle 5.11 version. The reason I stick with it is that it is a full version, enabling me to make boards at 10x16 cm. But Jim's schematic of the VUCswitch again showed its vulnarabiliy: it cannot read V7.70 schematcs. My V7.5 version can but as a free version is limited in board size. I just found out that Eagle is a part of AutoDesk (remember AutoCAD?) now. Shouldn't be a problem but I often have the feeling when taken over by a big company, the product becomes worse. Conformation: it is only available in 64 bits. -- Kind regards / Met vriendelijke groet, Ruud Baltissen www.Baltissen.org Message was sent through the cbm-hackers mailing listReceived on 2017-11-09 21:00:02
Archive generated by hypermail 2.2.0.