Hello Ruud, * On Tue, Jun 05, 2018 at 06:43:16AM +0000 Baltissen, GJPAA (Ruud) wrote: > I ran into another similar problem, "ncurses.h", but I solved that one myself using Google. But unfortunately I'm not there yet. According your quick installation walk-through: > - Compile OpenCBM - went fine after your help > - Install OpenCBM package - went fine > - Connect your cable - wnr fine > - Switch on your CBM IEC device - CBM 8250LP (*) > - XA1541 + XM1541only - skipped that > - cbmctrl reset - command not found > - make -f LINUX/Makefile ldconfig - ldconfig not found What is your path (try by issuing the command "echo $PATH")? By default, OpenCBM installs itself in /usr/local/bin/. It must be in your path in order for the tools to be found. You can also try to run /usr/local/bin/cbmctrl "by hand" by using the full path. Is it found? > cbmctrl is there in a subdirectory but "cbmctrl" on itself won't work > and "./cbmctrl" or "cbmctrl/cbmctrl" won't work either; files not > found. Am I missing something else? cbmctrl/cbmctrl should work. What is the exact error message? Does it differ to the error message that you get when you just issue a cbmctrl (without a path)? > (*) I only now see that it reads IEC. IMHO it is supposed to work for > IEEE as well. Whether if this is something that should be corrected or > not, IMHO cbmctrl as command should have worked anyway. Yes, this applies to IEEE devices, too. I should change the wording a little bit. Regards, Spiro. -- Spiro R. Trikaliotis http://www.trikaliotis.net/Received on 2018-06-05 21:00:04
Archive generated by hypermail 2.2.0.