Hi Baltissen, Thanks for sharing. My first roadmap it's to develop my prototype in development platform and lateral try to design a custom board. Also, i have considered to implement the prototype in the U2+ and then, to allow the community to reuse the hardware bought already for them (this is a possibility but first let me see to achieve the project hahaha). Right now, i don't have a U2+, i'm seeking to get one from Gideon with a safe shipping service because the postal service in my country is awful. Cheers, Luis Vela dsp8bit El jue., 19 de jul. de 2018 1:13 AM, Baltissen, GJPAA (Ruud) < ruud.baltissen@apg.nl> escribió: > Hallo Luis, > > > > how is the signaling exchange between the C64 and the SCPU > > The SuperCPU disables the 6510 and takes over the C64. I don't know > exactly how but this page has info on the CP/M card for the C64: > > http://baltissen.org/newhtm/c64_cpm.htm > > It includes a schematic and should give you an idea how the 6510 can be > stopped and put in tri-state and how the a-synchronous Z80 handles the > transfer of data between itself and the C64. This could be a starter for a > simple design where the 65816 just runs at 1 MHz and does nothing else than > replacing the 6510. Next step could be to make the 65816 run at an odd > frequency like 5Mhz just to make sure that the synchronization works. Then > it is adding RAM, ROM and I/O to the design. > > When I bought the 1541Ultimate one of the ideas was to use as a > development platform as well. Particularly I had the SCPU in mind. But I > soon found out it was way above my head: no FPGA knowledge :( But I thought > that what I could not, maybe others could. So I convinced Gideon to make > the Ultimate open source. Maybe something for you? > > Regarding my FPGA knowledge: I bought a Godil and did some small projects > with it. But it convinced me that the Ultimate is still out of my league > yet :( > > Good luck and have fun! > > > Met vriendelijke groet / With kind regards, Ruud Baltissen > > www.Baltissen.org > > > > > > > De informatie in dit e-mailbericht is vertrouwelijk en uitsluitend bestemd > voor de > geadresseerde. Wanneer u dit bericht per abuis ontvangt, verzoeken wij u > contact op te > nemen met de afzender per kerende e-mail. Verder verzoeken wij u in dat > geval dit > e-mailbericht te vernietigen en de inhoud ervan aan niemand openbaar te > maken. > Wij aanvaarden geen aansprakelijkheid voor onjuiste, onvolledige dan wel > ontijdige > overbrenging van de inhoud van een verzonden e-mailbericht, noch voor > daarbij > overgebrachte virussen. > > APG Groep N.V. is gevestigd te Heerlen en is ingeschreven in het > handelsregister van de Kamer van Koophandel Limburg onder nummer 14099617 > > > The information contained in this e-mail is confidential and may be > privileged. > It may be read, copied and used only by the intended recipient. > If you have received it in error, please contact the sender immediately by > return e-mail; please delete in this case the e-mail and do not disclose > its > contents to any person. We don't accept liability for any errors, > omissions, > delays of receipt or viruses in the contents of this message which arise > as a > result of e-mail transmission. > > APG Groep N.V. is registered in the trade register of the Chamber > of Commerce Limburg, The Netherlands, registration number: 14099617 >Received on 2018-07-19 16:00:04
Archive generated by hypermail 2.2.0.