>Try to change C11 (I'm assuming you have a VIC-20CR, the one with 2 x >6116 SRAMs and 3 x 2114 SRAMs) >On the old VIC-20, the one with all 2114 SRAMs, it's labeled C16. If >this doesn't solve the problem, then try changing Q1 (new VIC-20CR) or >Q5 (old VIC-20). But you should first check that the transistor is >really bad or if it's just a failed connection or polarization >resistor etc... (most of the checks can be done with a simple >multimeter). Yes, I've a VIC-20CR. I measured the c11 capacitor with multimeter and its value is 1microF and no resistance between two pole. About transistor Q1, I measured the voltage between base-collector and base-emitter either with red or black( probe of the multimeter) connect to base and the results are: base (red probe) vs collector (black robe) 0.7160 Volt base (red probe) vs emitter (black robe) 0.7160 Volt base (black robe) vs collector (red probe) 1.596 Volt base (black robe) vs emitter (red probe) 1.80 Volt This check is made withoout remove any componet from matherboard. It doesn't work for you? It need to replace? I read on the transistor C2548. I've found on internet the wiring diagram of VIC-20, but not VIC-20CR, Where I can find it? -- Sent from: http://cbm-hackers.2304266.n4.nabble.com/Received on 2019-01-07 02:03:38
Archive generated by hypermail 2.2.0.