On 3/25/2020 11:31 AM, silverdr_at_wfmh.org.pl wrote: > >> On 2020-03-25, at 16:35, Spiro Trikaliotis <ml-cbmhackers_at_trikaliotis.net> wrote: >> >> [...] >> Thus, if your setup allows one switched off controller, the procedure >> can be: >> >> 1. Switch on all drives and computer 1 >> 2. If it is a C64, do the LOAD (or the POKE) as given above >> If it is a C128, wait until the boot access has stopped and you see >> the power on message >> 3. Switch on the other computer 2 >> If it is a C64, do the LOAD (or the POKE) as given above > But if computer 1 has the board with RESET passed through then you'd need to do the LOAD from there again, which wouldn't work because computer 2 would be holding the line ;-) So I guess the safest would be to do the POKEs (rather than LOADs) on both computers, after everything is turned on. > To test, I unplugged the IEC cable from 1 machine, did a bogus load from both, and then reconnected the cable. Jim -- Jim Brain brain_at_jbrain.com www.jbrain.comReceived on 2020-05-30 01:25:08
Archive generated by hypermail 2.3.0.