Hi Dave, the equations are available, I'd sincerely like to find the abel program to obtain the proper jedec myself. I've seen that some of the fuse map is bit-swapped on the jedec file available on zimmers. I've checked against the partial other jedec map contained in pla.txt. However not all fuse pairs are swapped, so I haven't still figured out how to obtain a correct file. I have no "real" 82S100 to read with my 2900 to have the correct file. On Sun, May 24, 2020 at 6:48 PM dave_m <dmercado11_at_att.net> wrote: > > Gentlemen, > Another issue with that JED file is that there are no test vectors included > in the file. That means there can be NO verification of proper output states > after fusing. The Verification test may pass, but nothing is really tested. > > The output pins can not be tested by the PLA Programmer without test > vectors. Any output pin may be dead and no one can tell after fusing. The > first 'test' then is when the PLA is placed on the board and run > operationally. > > If someone has a Truth Table of the 16 inputs vs the 8 outputs for all 48 > Product Terms, the Test Vectors can be created. > > > > -- > Sent from: http://cbm-hackers.2304266.n4.nabble.com/ >Received on 2020-05-30 01:49:29
Archive generated by hypermail 2.3.0.