Hallo Prof, I collected the keyboards of some bad C='s especially for this purpose. > If you didn't want to do this, the only other method is to heat a sewing pin > up until its red hot and drive it through the broken star and lower part in > one go. When it cools, snip the protruding part of the pin. If all goes > well, both parts should stick to the pin. I used the same trick in the middle of the 80's. I assume that with "sewing pin", Nick means the needle with the hole on the end. I used the ones with a little knob on the end. If nick meant these as well, I second his solution. Groetjes, Ruud http://Ruud.C64.org - This message was sent through the cbm-hackers mailing list. To unsubscribe: echo unsubscribe | mail cbm-hackers-request@dot.tml.hut.fi.
Archive generated by hypermail 2.1.1.