Hi All,
I'm looking to interface something which will clock both CNT1/CNT2 via the
userport to shift in data on SP1/SP2.
As I understand it, CNT1/SP1 is used as the burst interface on a C128 in
C128 mode.
If I connected the interface to the userport and used all four signals I
intend to, will the internal circuitry disconnect activity on CNT1/SP1 from
the userport so that burstmode continues to work without having to
physically unplug the device?
Cheers,
Nick
PLEASE TAKE NOTE:
The contents of this email (including any attachments) may be
privileged and confidential. Any unauthorised use of the contents
is expressly prohibited. If you have received this email in error,
please advise us immediately (you can contact us by telephone
on +61 8 9441 2311 by reverse charge) and then permanently
delete this email together with any attachments. We appreciate
your co-operation.
Whilst Orbital endeavours to take reasonable care to ensure
that this email and any attachments are free from viruses or other
defects, Orbital does not represent or warrant that such is explicitly
the case
(C) 2000: Orbital Engine Company (Australia) PTY LTD and its
affiliates
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail 2.1.1.