From: matt (galaga_at_paradise.net.nz)
Date: 2004-10-27 07:18:50
pin 2 on the modulater "m1" and audio on pin 1
----- Original Message -----
From: "Cameron Kaiser" <spectre@floodgap.com>
To: <cbm-hackers@ling.gu.se>
Sent: Wednesday, October 27, 2004 12:27 PM
Subject: tapping Ultimax composite output
> I'm looking at the inside of my Ultimax and trying to figure out where I
> can best obtain a composite signal (my Mac can tune Japanese frequencies
> but not my TVs). According to Ruud's schematic at
>
> http://www.funet.fi/pub/cbm/schematics/computers/c64/ultimax.gif
>
> it looks like it's coming off C36? Or where can I tap into the input of
the
> RF modulator? I don't find an obvious source leading in unless I'm walking
> right by it. I'd prefer something I can clip to rather than solder to,
since
> I don't want to ruin this unit! ^_^;;
>
> --
> ---------------------------------- personal:
http://www.armory.com/~spectre/ --
> Cameron Kaiser, Floodgap Systems Ltd * So. Calif., USA *
ckaiser@floodgap.com
> -- Research is what I'm doing when I don't know what I'm doing. -- W. von
Braun
>
> Message was sent through the cbm-hackers mailing list
>
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.