Antitrack_at_networld.at
Date: 2008-01-27 20:58:35
Hi dudes,
I'm very sorry of admitting to just how lousy a hardware-man I am.
When I got the 1541-IDE kit from Al Anger, I immidately noticed that I
could not tell at first glance which side of the board ought to have
the parts on, and which is actually side 2. :-(
Furthermore, since no extra information is ever written on the board,
I'm very unsure of where to place the couple of resistors, the couple
of condensators, and which way to place the 40-pin IDE connector -
I bet if I do it without any further information, I end up doing it all
the WRONG way. :(
The same is true for the TTL-chips, etc.
So please allow me to ask for more, detailed, large photos on how to properly
assemble the board, where to place the resistors/condensators, etc?
Greatly appreciated,
Yours
ATT
--------------------------------------
Ein Service von http://www.networld.at
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.