Update: On http://www.ktverkko.fi/~msmakela/8bit/c2n232/software/ I found c2nload version 1.0.6.1 Unfortunately with this one I only get a: ----------------- c2nload -c /dev/ttyUSB0: unexpected response from C2N232 device ----------------- I'll try the 1.0.5 version now just to be sure André -------- Original-Nachricht -------- > Datum: Fri, 06 Aug 2010 21:34:06 +0200 > Von: "André Fachat" <afachat@gmx.de> > An: cbm-hackers@musoftware.de > Betreff: c2n232 question (PET 8032/8296) > > Hi, > > I have a question concerning c2n232 operation with a USB-to-RS232 adapter > on the PC (using Linux) > > The c2n232 setup works on a normal PC, so it is not essential to make it > work but it would be nice. When I connect it to the laptop with the USB > adapter, I can run c2nload, but on the CBM side I only get to the "searching" > state. > > On the Linux side I get > ------------- > writing 12224 bytes... done > c2nload: loader started, loading the file. > c2nload -c /dev/ttyUSB0: C2N232 responded 0x00; expected '@' > ------------- > > The USB adapter I have uses the prolific pl2303 adapter chip. > That's what the kernel says > ------------- > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.175669] usbcore: registered new > interface driver usbserial > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.175693] USB Serial support > registered for generic > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.175734] usbcore: registered new > interface driver usbserial_gene > ric > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.175740] usbserial: USB Serial > Driver core > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.192089] USB Serial support > registered for pl2303 > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.192131] pl2303 3-2.2:1.0: pl2303 > converter detected > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.204182] usb 3-2.2: pl2303 > converter now attached to ttyUSB0 > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.204245] usbcore: registered new > interface driver pl2303 > Aug 5 23:43:31 linux-4k3b kernel: [ 9280.204265] pl2303: Prolific PL2303 > USB to serial adaptor driver > ------------- > > In this old post > http://www.softwolves.com/arkiv/cbm-hackers/11/11241.html > Marko writes that it should work with this IC though. > > I am not sure if I have the correct software versions. I use c2nload-1.0.4 > from the cbm archive (and cbmlink-0.9.7 but I don't get to that with the > laptop and USB adapter). Don't know how to find out the c2n232 version > though. > > Any ideas? Maybe Marko? > > Thanks for any help > > André > > > -- > GRATIS für alle GMX-Mitglieder: Die maxdome Movie-FLAT! > Jetzt freischalten unter http://portal.gmx.net/de/go/maxdome01 > > Message was sent through the cbm-hackers mailing list -- GMX DSL SOMMER-SPECIAL: Surf & Phone Flat 16.000 für nur 19,99 ¿/mtl.!* http://portal.gmx.net/de/go/dsl Message was sent through the cbm-hackers mailing listReceived on 2010-08-06 20:00:29
Archive generated by hypermail 2.2.0.