Hi all, I am still working on the disk transfer. I first want to try a software transfer by copying the data byte for byte. I made this small program 10 nm$="8032-700-asc-ns" 20 open 2,8,2,"1:"+nm$+",p,r" 30 open 3,9,3,"0:"+nm$+",p,w" 40 get#2,a$ 50 if st=64 then goto 80 60 print#3,a$;:goto 40 80 close 2:close 3 90 end The program makes a copy, but the file size of the copy is smaller than the original (Example: original 81 Blocks, copy 79 Blocks) Is there an error in my program? The source (8) drive is a 8250lp, destination (9) is a MicroPower 2000 (4040) and the computer is an 4032. Or is it the difference in floppy formats? Richard Op Zo, 30 oktober, 2011 9:59 pm schreef Nate Lawson: > On Oct 30, 2011, at 1:03 PM, r.lagendijk@hccnet.nl wrote: > > >> Hi all, >> >> >> I want to transfer programs from a 8250 diskette. I have a CBM 4032, a >> 8250lp and a datassette. >> >> >> I loaded the first program from disk and saved it to a tape. I read the >> tape with MTAP in my PC and I could load the .tap into VICE. >> >> So far so good. But the next program on the diskette freezes the PET, I >> think because it's not a BASIC program but MC and it loads in an >> memory location not so good for my 4032. The programs on the disk are >> made for a CBM 700 series. >> >> >> Is there a way to solve my problem? >> > > > The ZoomFloppy with IEEE-488 plug attached can read from the 8250 drive. > You'd just plug it in and read the file off with cbmcopy or the entire > d82 image with d82copy. > > -Nate > > > > Message was sent through the cbm-hackers mailing list > > -- www.richardlagendijk.nl Message was sent through the cbm-hackers mailing listReceived on 2011-11-05 12:00:04
Archive generated by hypermail 2.2.0.