Hallo allemaal, I have a problem with my CMD-100 that I cannot explain plus some questions. At this moment an IBM WDS-3160S has been attached. It works fine AFAIK but it is old. First my questions: - It has for example a CP/M PLUS partition but so far I haven't found out how to start up from it then to CP to it and issueing a SYS command to reset the C128. The MCOPY command should copy a partition an equal device. This CP/M partition is a 1581 partition so it should be possible to MCOPY it to a 1581 floppy. After starting the program and setting it, it load some drivers and then says it is configuring the drives. And then nothing, no drive activity or what ever :( - I used FCOPY to copy files from a partition with the HD utilities to a 1581 floppy. Doing the same to a 1571 floppy ends up in an error. Still 836 blocks free so, what can be the error ???? - IIRC I saw a screen shot of a program showing the IDs of the attached drives, CDROMs or what ever. What program (or am I wrong)? Now the problem: I cannot attach another disk :( I tried several disks and in most cases I got a " SCSI error 133". In one case #63 and in another #2. In some cases the disk wouldn't spin up, even though it should IMHO according the jumper settings. FYI: that after pushing the SWAP8 & 9 + RESET button plus running the "CREATE SYS" (?? forgot the exact name) program. What am I doing wrong or forgetting? -- ___ / __|__ / / |_/ Groetjes, Ruud Baltissen \ \__|_\ \___| http://Ruud.C64.org Message was sent through the cbm-hackers mailing listReceived on 2012-01-29 15:00:05
Archive generated by hypermail 2.2.0.