On 2014-06-25 at 11:37:07, silverdr@wfmh.org.pl (silverdr@wfmh.org.pl) wrote: > Having said that - I am still very curious what would be the output. It is so small that maybe > you can try just a quick shot of a generic gear that has the (I don't know the English terms > for the gear parameters) outer diameter of 3.7mm and 1.5xx (don't remember exactly - > maybe somebody can check it directly with his device) inner hole. There should be some > generic designs with appropriate number of teeth that one could resize. Not to work with > this one later but just to have a kind of POC if spending time on exact reversing the actual > gear makes sense as of now. AFAIR it is similar to this type http://www.gizmoszone.com/shopping/html/images/GM031019.gif I think the bore should be 1.5mm (the shaft was somewhat more than 1.5, which it should be) and the outside diameter of 3.7 mm and 13 teeth. But someone here should be able to verify and measure the thing more accurately than what I recall. -- SD! Message was sent through the cbm-hackers mailing listReceived on 2014-06-25 11:00:02
Archive generated by hypermail 2.2.0.
