On Wed, Dec 20, 2017 at 3:49 PM, Pete Rittwage <peter@rittwage.com> wrote: >> On Wed, Dec 20, 2017 at 2:46 PM, Pete Rittwage <peter@rittwage.com> wrote: > > Most of the time, the issue with those is the top head does not apply > proper or even pressure for the bottom head to read. If it sits > open/unlocked for years and years, the little metal ribbon bends/warps and > causes this. I would carefully check that first. > > http://personalpages.tds.net/~rcarlsen/cbm/1571/1571diag.txt yes I know this page, but I haven't found a clue so far. It might be out of alignment. One thing that I noticed is that when formatting a disk that goes to track 35, it seeks back to track 0 for checking every track (I think) and fails immediately after seeking back to track 0, like if the sensor (that I cleaned), would not function properly... I'll try using the diagnostic programs, those maybe will give me some more hints. Frank Message was sent through the cbm-hackers mailing listReceived on 2017-12-20 16:00:02
Archive generated by hypermail 2.2.0.