wlevak_at_cyberspace.org
Date: 2003-06-17 06:24:16
The +5 volts comes from a 7805 voltage regulator, which has built in
current limmiting. You can't overdraw it.
On Mon, 16 Jun 2003 Gianmario.Scotti@nokia.com wrote:
> Hello!
>
>
> I got hold, through a purchase of some old junk, of an Amstrad joystick. I boldly proceeded to try it out on my C-64, but noticed something is not quite right. Note that the C-64 didn't reset.
>
> So then I went to check out the Amstrad joystick port pinning, and found out that it uses pin 7 for the Fire 1 button. This deviation from the Atari "standard" is rather alarming, since on the C-64 pin 7 is connected to +5 Vcc. Further analysis of my Commodore showed that the joystick port is still intact and functional.
>
> How can this be? According to the C-64 schematic (this part of the schematic should be common to all revisions) http://www.funet.fi/pub/cbm/schematics/computers/c64/250469-rev.A-left.gif pin 7 goes directly to the system's +5 Vcc. So when I pressed the Fire 1 button, I should have fried one of the fuses, or at least reset the system - which didn't happen.
>
>
> thanks in advance
>
>
>
> mario
>
>
>
> Message was sent through the cbm-hackers mailing list
>
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.