From: Konrad B. (Konrad.B_at_poczta.neostrada.pl)
Date: 2003-07-09 13:07:05
> It's the power and ground pins on four-layer and thicker boards that
> are ever stubborn. One trick that works (with practice) is to
> mount the board vertically (best done in a vise meant to hold circuit
> boards, not a vise for lumber), put the heat in from one side, and
> suck the solder out from the other.
It's the method I'm using. I learnt it from my friend, who was working in C= service here in Poland :)
If I need more heat (in case of huge ground/power planes), I use heated desoldering pump instead of regular (non heated) one.
K.B.
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.