From: Cameron Kaiser (spectre_at_floodgap.com)
Date: 2004-10-27 01:27:22
I'm looking at the inside of my Ultimax and trying to figure out where I
can best obtain a composite signal (my Mac can tune Japanese frequencies
but not my TVs). According to Ruud's schematic at
http://www.funet.fi/pub/cbm/schematics/computers/c64/ultimax.gif
it looks like it's coming off C36? Or where can I tap into the input of the
RF modulator? I don't find an obvious source leading in unless I'm walking
right by it. I'd prefer something I can clip to rather than solder to, since
I don't want to ruin this unit! ^_^;;
--
---------------------------------- personal: http://www.armory.com/~spectre/ --
Cameron Kaiser, Floodgap Systems Ltd * So. Calif., USA * ckaiser@floodgap.com
-- Research is what I'm doing when I don't know what I'm doing. -- W. von Braun
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail pre-2.1.8.