On 11/10/2017 4:10 AM, silverdr@wfmh.org.pl wrote: > > I hated the fact that I was not able to put all the supplies and bypasses in a dedicated schematics area but had to clutter the main schematic instead. Can you show an example? I *think* I know what you mean by putting all supplies and bypasses ina area (I put mine in the bottom left of the sheet that holds the IC they are for, with main VRs and board level bypasses on a separate sheet), but I am unclear on how KiCAD makes you place them. > But OK, I did it. Everything looked OK. I got no ERC errors, nothing, and the board would be unusable anyway because two chips were not connected to power/GND plane. Luckily I am used to eyeball the gerbers for possible last minute corrections. Ooh, no ERC errors either? Surely that's a bug someone is squashing, as I would think that is foundational. Jim Message was sent through the cbm-hackers mailing listReceived on 2017-11-10 16:00:03
Archive generated by hypermail 2.2.0.