I removed the regulator from the board. The situation is now the following: - the resistance between ground and output of the regulator (on the board) is 25 Ohm - the resistance between ground and output of the regulator (on the regulator itself) is 10 KOhm - the voltage between ground and the output pin of the capacitor / input of the regulator is now oscillating between 0 and 2V approximately. I have also disconnected the L701 inductor, or at least what I think is the L701 inductor, but that didn't make any difference. Incidentally, I think I might have damaged it while pulling it out... Is it a difficult part to find a replacement for? I'll probably be able to make some more measurements later this week. -- Sent from: http://cbm-hackers.2304266.n4.nabble.com/ Message was sent through the cbm-hackers mailing listReceived on 2018-02-25 23:00:03
Archive generated by hypermail 2.2.0.