From: Anders Carlsson (anders.carlsson_at_mds.mdh.se)
Date: 2002-10-03 10:10:34
On Thu, 3 Oct 2002, Mikael Holm wrote:
> Does the pins on the "down-side" of the cassette port get the same set
> of signals as the upper counterpart?
Yes, according to the pinout found in manuals it does at least. Notice
that pin 1 is ground (but it will probably prevent your tape drive from
working no matter what's missing). From the VIC-20 PRG:
1 2 3 4 5 6 A-1 = GND B-2 = +5V C-3 = Motor
A B C D E F D-4 = Read E-5 = Write F-6 = Switch
(not sure if this design is from the computer or connector view, though)
--
Anders Carlsson
Message was sent through the cbm-hackers mailing list
Archive generated by hypermail 2.1.4.