Den Sun, 25 Feb 2018 14:40:05 -0700 (MST) skrev Sherry Haibara <v.castelli92@gmail.com>: > I'll take the capacitor and the diodes out to test them separately. > At this point I'm planning to replace the smoothing capacitor, the > regulator, the four diodes and the L701 inductor just to be safe. Start with just replacing the capacitor while you have the regulator removed. If you then still get strange readings then replace the diodes. > Do you know a modern equivalent of the 1N5403 that is easier to find? The 1N540x series are rated at 3A, so any diodes that can handle 3 amps should be good. > I'm also unsure about the correct replacement for L701, the > schematics show a "10F" value; F probably stands for ferrite, but is > 10 expressed in mH? If you get a few ohms or lower while measuring resistance on it, you can be sure it's not broken. P.S. make sure you use a good ground (the ground pin on the capacitor or the regulator) when measuring voltages. Strange values could be a result from mixing up chassis ground and signal ground. Not sure how this machine does with chassis v.s. signal ground though. -- (\_/) Copy the bunny to your mails to help (O.o) him achieve world domination. (> <) Come join the dark side. /_|_\ We have cookies. Message was sent through the cbm-hackers mailing listReceived on 2018-02-26 01:01:48
Archive generated by hypermail 2.2.0.