Re: firmware for 8296

Am 16. März 2018 21:16:55 schrieb Steve Gray <sjgray@rogers.com>:

Just a question (for any PET users)... would anyone be interested in a 
composite output solution that works on the USER PORT? I'm thinking of 
making a board with composite and RGBI  (for 1084 monitors etc) output, and 
perhaps an audio DAC as well.

Yes! I've rebuilt the CBM-II solution for my PET replica, but still looking 
for a setup for an unmodified pet e.g. to check the video signal or to test 
the board with many power cycles with the original monitor switched off to 
save it from the stress of being swtchd on and off all the time.

André



Steve


  From: didier derny <didier@aida.org>
To: cbm-hackers@musoftware.de
Sent: Friday, March 16, 2018 12:12 PM
Subject: firmware for 8296


Any chance to use a set of eprom for the 8032 in a 8296  ?

or there are some special initialization  ?


I was thinking to use   8032  basic / 8032 kernel / Steve editor rom for
8032 (using special config for composite + use of c64 keyboard)


thanks